Table of Contents
Advertisement
44
en | Configuration
5.6.4
Alarm Task Editor
Editing scripts on this page overwrites all settings and entries on the other alarm pages.
This procedure cannot be reversed.
To edit this page, you should have programming knowledge and be familiar with the
information in the Alarm Task Script Language document and the English language.
As an alternative to the alarm settings on the various alarm pages, enter the desired alarm
functions in script form here. This will overwrite all settings and entries on the other alarm
pages.
1.
2.
3.
5.7
Network
Notice!
i
Bosch recommends the use of industrial micro SD cards with health monitoring.
5.7.1
Network Services
This page shows an overview of all available network services. Use the checkbox to activate
or deactivate a network service. Click on the settings symbol next to the network service to
go to the settings page for this network service.
Click Set to apply the changes.
Some changes only take effect after the unit is rebooted. In this case, the Set button
changes to Set and Reboot.
5.7.2
Network Access
If the IP address, subnet mask, or gateway address is changed, then the device is only
available under the new addresses after the reboot.
IPv4
Automatic assignment (DHCP)
If the network has a DHCP server for the dynamic assignment of IP addresses, select On to
automatically accept the DHCP-assigned IP address.
For certain applications, the DHCP server must support the fixed assignment between IP
address and MAC address, and must be appropriately set up so that, once an IP address is
assigned, it is retained each time the system is rebooted.
IP address
Enter the desired IP address for the camera. The IP address must be valid for the network.
Subnet mask
Enter the appropriate subnet mask for the set IP address.
Gateway address
For the device to establish a connection to a remote location in a different subnet, enter the
IP address of the gateway here. Otherwise, this field can remain empty (0.0.0.0).
2024-02 | V01 | DOC
Click Examples under the Alarm Task Editor field to see some script examples. A new
window opens.
Enter new scripts in the Alarm Task Editor field or change existing scripts in line with
your requirements.
When finished, click Set to transmit the scripts to the device. If the transfer was
successful, the message Script successfully parsed. is displayed over the text field. If it
was not successful, an error message is displayed with further information.
User manual
DINION 3100i IR
Bosch Security Systems B.V.
Advertisement
Table of Contents
