Table of Contents
Advertisement
7. Put the condenser back inside the bottom compartment.
8. Close the condenser cover.
9. Lock the two blockages until they snap.
10. Close the condenser door.
12.4 Cleaning the humidity sensor
Risk of humidity sensor damage. Do not use abrasive materials or steel wool to clean the sensor.
To assure best drying results the appliance is equipped with metal humidity sensor. It is placed on the inner side of
the door area.
Over usage time the surface of the sensor may get dirty which deteriorates the drying performance.
We recommend to clean the sensor at least 3 or 4 times or if you observe the drop of drying performance.
To clean you can use harder side of dishwashing sponge and bit of vinegar or dish soap.
To clean the sensor:
• Open the loading door.
• Clean the surfaces of the humidity sensor wiping off the metal surface several times.
12.5 Cleaning the drum
Disconnect the appliance before you clean it.
Use a standard neutral soap detergent to clean the inner surface of the drum and drum lifters. Dry the cleaned surfa-
ces with a soft cloth.
Do not use abrasive materials or steel wool to clean the drum.
12.6 Cleaning the control panel and housing
Use a standard neutral soap detergent to clean the control panel and housing.
Use a moist cloth to clean. Dry the cleaned surfaces with a soft cloth.
Do not use furniture cleaning agents or cleaning agents which can cause corrosion to clean the appliance.
User manual
Caution
Warning
Caution
Caution
25
fig.X03361
Advertisement
Table of Contents
