Table of Contents
Advertisement
Mechanical Disassembly & Reassembly
This section provides disassembly & Reassembly procedures for PD527D Micro Portable XGA
DMD Projector (As a sample model). Before you begin any of these procedures, be sure to
turn off the power, computer system, and other attached devices; then disconnect the power
cable from the electrical outlet. Moreover, when you disassemble the projector, be sure to
put the screws in a safe place and separate them according to their category.
(For PD523PD, you can refer to this sample disassembly & reassembly procedures for
instructions.)
Equipment Needed
Item
Philips (+) : 107
Screw Bit
Tweezers
General Information
Before You Begin
Before proceeding with the disassembly procedure, make sure that you do the following
procedures:
1. Turn off the power of the system and all the peripherals.
2. Unplug the AC adapter and all power and signal cables from the system.
3. Anti-static wrist strap.
Chapter 3
Photo
Philips (+) : 102
Hex Screw :
5mm
Screw Bit
Item
Chapter 3
Photo
20
Advertisement
Table of Contents
