Uniden EXAI 398 Series Owner's Manual page 11

EXAI398 12/26/2 10:32 AM Page 11
C. Connect the base unit
1) Connect the AC adapter to the DC IN 9V jack and a
standard 120V AC wall outlet.
2) Set the base on a desk or tabletop, and place the
handset on the base unit as shown. (For wall mounting,
see "Mounting the Base Unit on a Wall", on page 12.)
3) Raise the antenna to a vertical position.
4) Make sure the charge/in use LED illuminates. If the LED
does not illuminate, check to see that the AC adapter is
plugged in and the handset makes good contact with
the base charging contacts.
• Connect the AC adapter to a continuous
power supply.
• Place the base unit close to the AC outlet so that
you can unplug the AC adapter easily.
• After installing the battery pack in the handset, charge your handset at least
15-20 hours before plugging into the phone line. Once the handset battery pack is fully
charged, connect the telephone line cord to the base and telephone wall outlet.
5) Connect the telephone line cord to the TEL LINE jack
and a telephone outlet once the handset is fully
charged.
If your telephone outlet isn't modular, contact
your telephone company for assistance.
www.uniden.com
Modular
G E T T I N G S T A R T E D
• Place the power cord so
that it does not create a
trip hazard or where it
could become chafed
and create a fire or
electrical hazard.
• Use only the supplied
AD-420 AC adapter.
Do not use any other
AC adapter.
The handset can be placed
face up or face down in
the base for charging.
[ 11 ]