Tool Use; Actuation System - Senco TN51P1P Operating Instructions Manual

Tool use

read section titled "safety Warnings" before using tool.
1
uNlOaDiNg The TOOl:
Push Tab on feeder shoe to release feeder from strip. Pull fastener strip out past sheet metal nail detainer.
Do not load with workpiece contact (safety element) or trigger depressed.
Use only genuine SENCO fasteners (see Fastener Specifications).

actuation system:

With a Contact-actuation ("Dual-action") trigger, fasteners can be driven two ways:
2
1
1
2
2
1
read the "Customer satisfaction and safety reminder" (Cssr) in the tool and fastener boxes for safety infor-
mation regarding the Contact-actuation and sequential trigger modes. under certain conditions, the sequential
trigger mode may reduce the possibility of injury to you or to others working with you.
2
The First Way:
➀ Press the workpiece contact (safety element) against the work surface.
➁ Pull the trigger and the fastener is driven.
The second Way:
➀ Pull and hold trigger.
➁ Depress workpiece contact element against work surface and drive a fastener. Each
time you push the workpiece contact (safety element) against the work surface, a fastener
is driven.
This mode of operation is preferred when you desire high production, and rapid fastener
placement.
With a sequential actuation (restrictive) trigger, fasteners can only be driven one
way:
➀ Press the workpiece contact (safety element) against the work surface.
➁ Pull the trigger.
This mode of operation is helpful when you require precise fastener placement.
TO lOaD:
➀ Insert strip of nails into rear of magazine
➁ Pull feeder shoe back.
9