Poulan Pro PP258TP Instruction Manual page 11

STARTING A FLOODED ENGINE
Flooded engines can be started by placing
the ON/OFF switch in the ON position. Move
the start _ever to the RUN position and fully
squeeze throttle trigger Pull the starter han-
dle repeatedly while squeezing throttle trigger
until engine starts and runs. This could re-
quire pu$1ing the starter handle many times,
depending on how badly the unit is flooded.
If the unit still doesn't start, refer to
TROUBLESHOOTING TABLE or call
1-800-554-6723.
OPERATING THE COUPLER
This model is equipped with a coupler which
enables opedna_ attachments to be instal}ed.
The optional attachments are:
MODEL:
Edger ....................... PP1OOOE
Cultivator .................... PP2000T
Blower ...................... PP3000B
Brushcutter .................. PPg000C
,_ WARNING:
Always stop unit and dis-
connect spark plug before removing or instal-
ling attachments.
REMOVING PRUNER ATTACHMENT
(OR OTHER OPTIONAL ATTACH-
MENTS)
CAUTION: When removing or installing at-
tachments, place the unit on a flat surface for
stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Upper Shaft
Coupler
LOOSEN
Lower
Attachment
TIGHTEN Knob
2. Press and hold the locking/release button
Locking/Release
Button
Upper Shaft
Lower Attachment
3. While securely holding the engine and
upper shaft, pull the attachment straight
out of the coupler
INSTALLING OPTIONAL ATTACH-
MENTS
1. Remove the shaft cap from the attach-
ment (if present).
2. Position Iocking/re_ease button of attach-
ment into guide recess of coupler
3. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
4-. Before using the unit, tighten the knob se-
curely by turning clockwise
Upper Locking/ Attachment
Shaft Release
Button
_i, WARNING: Make sure the locking/
release button is locked in the primary ho_e
and the knob is securely tightened before op-
erating the unit. All attachments are designed
to be used in the primaryhole unless otherwise
stated in the applicable attachment instruction
manual. Using the wrong ho_e could lead to sed-
ous injury or damage to the unit.
Secondary Hole
Locking/Release
Button in Primary Hole
INSTALLING ATTACHMENT
HANGER
An attachment hanger _sprovided for storage
when attachment is not in use.
To install hanger on attachment:
1. Remove the shaft cap from the attach-
ment (if present) and discard.
2. Press and hold the locking/release button.
3. Push hanger onto the attachment until the
locking/releasebutton snaps into the hole.
OPERATING INSTRUCTIONS
It is recommended that the engine not be
operated for longer than 1 minute at full
throttle.
OPERATING POSITION
i
ALWAYS WEAR: _, ,_
Head
protection Eye i
_
_ecti_i protection ';
1 Beavy
11