Panasonic Digital Palmcorder Multicam PV-DV92 Operating Instructions Manual page 96

Hide thumbs Also See for Digital Palmcorder Multicam PV-DV92:
Table of Contents

Advertisement

On-Screen Displays (OSD)
The following warning displays appear in the EVF and the LCD monitor.
_ Indicatioris, . . Condition
|
B
ac
If the Palmcorder is in CAMERA
mode without a cassette inserted,
ENO
'aof will flash and "TAPE NOT INSERTED" will appear for
INSERTED
5 seconds. Recording will not start.
If the Palmcorder is in CAMERA mode or Audio dub mode with
the cassette sliding record tab opened, ao) will flash and
"CHECK REC TAB' will appear for 5 seconds. Recording will not
start.
xi
When Audio dub is performed and the recording in other than
-Ba-
NTSC format, "aoj' will flash and "CANNOT REC" will appear for
-ÈA enb-
When the tape is about to end in REC mode, ao] END" will
TAPE END
flash and "TAPE END" will appear for 5 seconds.
INCOMPATIBLE
When an incompatible tape is detected, "INCOMPATIBLE
TAPE
TAPE" will appear for 5 seconds.
NEED HEAD
If the video heads require cleaning, "NEED HEAD CLEANING"
CLEANING
will appear for 5 seconds.
When the Palmcorder and remote are not set to the same mode
REMOTE
(VCR1 or VCR2), "CHECK REMOTE MODE (REMOTE)"' appears
for 5 seconds. It also appears when the Palmcorder is first turned
on.
CANNOT REC
When an AUDIO DUB is attempted on a pre-recorded LP tape,
LP-MODE
"CANNOT REC LP-MODE" will appear for 5 seconds.
If excessive moisture condenses in the unit, "WARNING?" will
flash, "DEW DETECTED?' will appear, and the Palmcorder will
automatically turn OFF in 15 seconds.
In this case, wait until the indicator no longer flashes when your
Palmcorder is turned ON again.
When a battery recharge is necessary, "WARNING" will
flash, "LOW BATTERY" will appear, and the Palmcorder will
automatically turn OFF in 15 seconds. (p. 108)
CHECK
REC
TAB
salsa,
— WARNING ~-
naa y
DEW DETECTED
— WARNING
SS
4x1 »>N
LOW BATTERY
CLOCK BATTERY
When the built-in lithium clock battery is discharged, "CLOCK
BATTERY" will appear. To re-charge the lithium clock battery,
connect the AC Adaptor to the Palmcorder. Recharging takes
approx. 4 hours. Reset the clock after charging.
96
For assistance, please call: 1-800-21 1-PANA(7262) or send e-mail to : consumerproducts@ panasonic.com :

Advertisement

Table of Contents
loading

Table of Contents