Panasonic Digital Palmcorder Multicam PV-DV92 Operating Instructions Manual page 46

Editing Features
Equipment (dubbing)
+ Connect both Palmcorders to their
: apra A ower sources.
High quality digital-to-digital copying can ° Connect the two Palmcorders using the
be accomplished if both Palmcorders
incorporate the DV Input/Output (i.LINK)
DV Interface cable (i.LINK)
(4-pin to 4-pin).
Connector (DV Interface cable (i.LINK) is
not supplied).
* Turn both Palmcorders ON.
Source (Playing) 1
Palmcorder Insert a pre-recorded tape into the
a
source (playing) Palmcorder, and set
z POWER to VCR.
DV Input/Output A
R Insert a blank tape with the record
(i.LINK) Connector tab closed into the arga ore)
Palmcorder and set POWER to VC
Recording 3
Palmcorder
Press » (PLAY) on the source
Palmcorder. When the tape reaches
the point you want to start dubbing,
press I} (PAUSE).
DV Interface
Cable (i.LINK)
(optional) Hold down REC and press » (PLAY)
on the target (recording) Palmcorder or
on the remote control (optional).
Press I] (PAUSE) to pause the tape at
the starting point of the dub.
5 Simultaneously, press H (PAUSE) on
both units to begin dubbing.
6 Press E (STOP) on the recording
unit, and then press E (STOP) on the
playing unit to end dubbing.
* When two Palmcorders are used for
dubbing, it is recommended that the
Remote Control (optional) VCR1 or VCR2
setting be used to avoid improper-
operation.
CAUTION:
Unauthorized exchanging and/or
copying of copyrighted recordings may
be copyright infringement.