Table of Contents
Advertisement
ctrlX CORE
X3
plus
12.7
SD card
There is a slot (CD01) for the micro SD card on the front of the control. The SD card host controller
supports the version 2.0 (standard SDHC), i.e. the maximum supported capacity of an SD card is 32
GB.
Use only SD cards available as accessories, see
SD cards are formatted and tested for the control.
A correct functioning of other SD cards cannot be ensured.
12.8
USB interface
There is a USB interface (XF01) (type C, USB 2.0) on the front side of the control. The USB interface
can be used to connect USB storage media (only FAT16 and FAT32), scanners and similar USB devices.
The USB interface provides a voltage supply with DC 5 V and 0.5 A for external devices. The USB
interface is switched off up to the next voltage cycle if the current is exceeded.
The maximum cable length allowed is 3 m.
NOTICE
12.9
RJ45 interface
XF10
HMI and engineering port
XF50
Field bus master (EtherCAT)
XF51
GBit/s Ethernet (configurable)
XF23
Ethernet 10/100 MBit Ethernet (configurable)
XF24
Ethernet 10/100 MBit Ethernet (configurable)
XF56
Ethernet 10/100 MBit Ethernet (configurable)
XF57
Ethernet 10/100 MBit Ethernet (configurable)
XF58
Ethernet 10/100 MBit Ethernet (configurable)
XF59
Ethernet 10/100 MBit Ethernet (configurable)
12.10 Battery
A battery with battery holder (GB01) is included and working in the device upon delivery. Battery
designation: Lithium battery 3.0 V CR1025 (30 mAH).
The battery is used to buffer the real-time clock if the control is disconnected from voltage. A circuit
monitors the battery state.
For notes on changing the battery, see
A discharged battery causes an incorrect system time.
R911420136, Edition 01
Device damage due to external supply via the USB interface
The grounding at the 24 V power connector XD10 always has to be con-
nected.
⮫ Chapter 14.3 "Battery change " on page
⮫ Chapter 5.2 "SD card" on page
35 / 46
Battery
11. These
37.
Bosch Rexroth AG
Advertisement
Table of Contents
