Advertisement
Biceleie)(-s-Jarere)aiare|
Basic
operation
Symptom
sell
Cause
The tape is rejected after being
loaded.
aes
The cassette is inserted incorrectly.
Remedy
Insert the cassette correctly. (page 17)
The tape does not move.
For 4 seconds after the power is turned
on, the buttons do not function.
Wait until the blinking of the 1 indicator
The PAUSE button is activated. (The Il
indicator tights.)
goes off and then try again.
Press PAUSE to release pause.
|
The tape is wound completely.
Press <4 or kd button to rewind.
The sound is not heard.
Incorrect connections.
—|—
Connect properly. (page 13 and 14)
Incorrect operation of the connected
amplifier.
Operate the amplifier as required by the
deck operation. (Refer to the operating
instructions of the amplifier.)
Set the REC MONITOR switch to the
TAPE position.
Recording cannot be made.
Set to the SOURCE position.
The safety tab of the cassette is open.
Close the tab of the cassette. (page 17)
Incorrect position of the INPUT selector.
Set the REC MONITOR switch to the
TAPE position.
Set the INPUT selector correctly.
Set it to DIGITAL to record sound from
the equipment connected to the
COAXIAL IN or OPTICAL IN jacks.
Set it to ANALOG to record sound from
the equipment connected to the LINE IN
jacks.
Set to the SOURCE position.
The digital copy prohibit signal exists in
jack.
The sound is not heard from the
recorded tape.
The CAUTION indicator lights,
and no button does function.
recording level is turned down
completely.
(When recording the analog
input signal)
When recording analog input signals, the] Adjust the recording level by using the
Connect the source equipment to the
the source signal input to the digital input] LINE IN jacks.
REC LEVEL controls. (page 21)
Moisture condenses inside the unit.
Leave the unit as is, then turn on the
power. (page 4)
Defective or damaged cassette is
inserted.
Sub code cannot be written.
Remove the cassette.
The safety tab of the cassette is open.
Close the tab of the cassette. (page 17)
Start ID cannot be written during
recording.
seconds (18 seconds in the long-play
mode) from the end of another start ID.
Anew start ID cannot be written within 9 | Leave at least 9 seconds (18 seconds in
the long-play mode) from the end of
another start ID.
45
Advertisement
