Advertisement
Various Playback Operations
Repeat Play
To stop playing all selections repeatedly
Press REPEAT (1/ALL on the Remote Commander) until
"REPEAT ALL" goes off.
Note on the end of the repeated portion during
"REPEAT ALL" play
The tape is rewound to the beginning of the tape when one
of the following is detected.
e
End!D
e
Apblank section of more than 9 seconds
Playing a desired portion repeatedly
This function is available only for the tape portion where the
absolute time code (page 18) is written.
This operation can be performed only with the Remote
Commander.
1 Press A~B at the beginning of the desired portion
during playback.
The REPEAT A indicator blinks, and the portion for 3
seconds from the point where you pressed A+B, is
played back repeatedly (rehearsal function). The beginning
of the repeated portion will be the beginning of your
desired portion.
2 Press << or »> to adjust the "repeat start" point.
The "repeat start" point is shifted backward with <4 or
forward with mt, by 0.3 of a second.
REPEAT
3aG <— Blinks
rneHeaAsAL «<¢— Lights
When you pressed
bP twice
3 After setting the beginning of your desired portion at
the desired point, press A~B again.
The REPEAT A indicator lights.
4 Press A~B at the end of the desired portion.
"B" of the REPEAT A-B indicator blinks, and the portion for
3 seconds to the point where you pressed A~B, is played
back repeatedly (rehearsal function).
The end of the repeated portion will be the end of your
desired portion.
5 Press «44 or »» to adjust the "repeat end" point.
The "repeat end" point is shifted backward with <4 or
forward with mt, by 0.3 of a second.
REPEAT
asec
<—
Blinks
reneansat «g— Lights
0.6
*}<— When you pressed
<4 twice
36
After setting the end of your desired portion at the
desired point, press A~B again.
The REPEAT A-B lights, and the designated portion is
played back repeatedly.
To stop a desired portion repeatedly
Press A+B until the REPEAT A-B indicator goes off.
To designate the points A and B without the rehearsal
function
Press AB
immediately after performing the step 1 (point
A) and 4 (point B). (With this operation, step 2, 3, 5 and 6
should be skipped.)
Notes on the point of A and B
e
If point B is too close to point A, point B may not be set.
e
Be sure to set point A.
Point B cannot be set before A.
Notes
e@
You cannot perform the A-B repeat and the time search
functions at the same time.
@
You may not perform the A-B repeat function with the
beginning of the tape.
illustration of the points of A and B
Point where you pressed
A-B (step 2)
Point where you pressed
A-B (step 5)
Repeated portion
(3 seconds)
sEach time you
ipress >
— —>
—
Each time you press <4}
—
Each time you press <<
,
;
The repeated portion is played back 16 times, and the tape
stops.
+» Each time you press >>
0.3! 0.3
Advertisement
