Test Record; Test Failure; Instruments Specifìcations; Ia. Function Test Using The Hp 81533A - HP 8153A Service Manual

Recommended Test Equipment
A. Head Adapter Module HP 81533A
Optical Head HP 81520A or HP 81521B
Test/Cai Box P/N 08152-63201
Head Recognition Adapter P/N 08152-63211
Digital Multimeter with Test Leads HP 3466A
Test Cable P/N 15414-61603
Oscilloscope
OR
B. Sensor Module
HP 81530/1/2/6A
Test Record Results of the Function Test may be tabulated on the Test Record
provided at the end of the test procedures. It is recommended that
you fill out the Test Record and refer to it while doing the test.
Since the test limits and setup information are printed on the Test
Record for easy reference, the record can be also be used as an
abbreviated test procedure
(it
you are familiar with test procedures).
The Test Record can also be used as a permanent record and may be
reproduced without written permission from Hewlett-Packard.
Test Failure
li the HP8153A fails any Function Test, return the instrument to the
nearest Hewlett-Packard Sales /Service Office for repair.
Specifications are the characteristics of the instrument which are
certifìed. These specifications, listed in Appendix Care the limits
against which the HP8153A can be tested. Appendix C also lists
some supplemental characteristics of the HP8153A and should be
considered as additional inforrnation.
Instruments Specifications
Any changes in the specifìcations due to manufacturing changes,
design, or traceability to the National Institute of Standards and
Technology will be covered in a manual change supplement or revised
manual. The specifications listed here supercede any previously
published.
lA. Function Test Using the HP 81533A
The Function Test given in this section is using the HP 81533A
Optical Head Interface Module and the 08152-63201 Test/Cal Box
to check voltages and signals from and to the HP8153A Multimeter
Mainframe.
Functional Tests 2-3