Assembling And Disassembling The Instrument; Removing The Instrument Housing; Removing The Front Panel Assembly - HP 8153A Service Manual

Lightwave multimeter
Table of Contents

Advertisement

3
Assembling and Disassembling the Instrument
Except where noted, assembling the instrument is the reverse of the
procedure given for disassembling.
Removing the Instrument Housing
Note
You will need a TORX screwdriver to perform this
task.
1.
Make sure that the power cord is removed.
2.
Loosen the 2 TORX screws (T15x80) on the rear bezel and
remove
it.
3. Remove the screw on the bottom of the housing and pull the
instrument
out of the housing.
Removing the Front Panel Assembly
1. Remove the instrument
housing (see "Removing the Instrument
Housing")
.
2. Disconnect the flat-cable connector
(J302)
from the processor
board.
3.
Lift the upper and lower part of the plastic frame at the front of
the instrument
and push out the front panel
assembly,
(The front
panel assembly is clipped into the plastic frame.)
Assembling and Disassembling the Instrument
3-1

Advertisement

Table of Contents
loading

Table of Contents