Connecting The Vcr - Sony SLV-E811NP Service Manual

e-b
Ea ac aa ar ae ee aE I CE I re
Step 2: Setting up the remote commander (continued) E e 23s
Connecting the VCR
Manufacturer Code number Manufacturer Code number
Nordmende 35, 42 Seleco 14 RF MODULATOR
Orion 47, 48 Sharp 29
Panasonic 17,49 Siemens 39 Signal flow
Philips 06, 07, 08 Sinudyne 37 —— SO AERIAL IN
Phonola 18, 19 TEAC 67 AGI BEVALOUT
Pioneer 26 Telefunken 36 Jy _} '
Saba 12, 13 Thomson 43 to mains ase ae
Samsung 22, 23 Toshiba 38 Aerial cable
Sanyo 25 White Westinghouse 34
Schneider 46
1 Disconnect the aerial cable from yourTV
and connect it to AERIALIN onthe rear **EM*E
slates panel of the VCR. Binn
¢ If the TV uses a different remote control system from the one programmed to work Qe
with the VCR, you cannot control your TV with the remote commander.
© If you enter a new code number, the code number previously entered will be erased.
¢ When you replace the batteries of the remote commander, the code number 2 Connect AERIAL OUT of the VCR and 'shia
automatically resets to 01 (Sony). Reset the appropriate code number. the aerial input of your TV using the out
supplied aerial cable.
.C ei.
vince
3 AF Make sure RF MODULATOR is set to ON.
MODULATOR
OFF = ON
ARR _ MAR
4 Connect AC IN of the VCR to the mains
using the supplied mains lead. CO}en—_m=——=—
continued
8| Getting Started Getting Started [i