Specifications; Caractéristiques - Crown XLS 402 Operation Manual

XLS Series Power Amplifiers

6 Specifications

6 Caractéristiques
The following specifications apply to all models with 8-ohm loads unless otherwise specified.
Minimum Guaranteed Power
Puissance minimum garantie
Garantierte Mindestleistung
Potencia Mínima garantizada
per channel, both channels driven
par canal, les deux canaux pilotés
pro Kanal, beide Kanäle in Betrieb
por canal, ambos canales operando
1 kHz with 0.5% THD
Stereo, 2 ohms (per ch.)
Stereo, 4 ohms (per ch.)
Stereo, 8 ohms (per ch.)
Bridge-Mono, 8 ohms
Bridge-Mono, 4 ohms
Sensitivity (volts RMS) for full rated power at
4 ohms
Frequency Response (at 1 watt, 22 Hz - 20 kHz)
Signal to Noise Ratio below rated power (20 Hz to
20 kHz, inputs terminated)
A-weighted, below rated power
No weighting, below rated power
Total Harmonic Distortion (THD) at 1 full bandwidth
power, from 20 Hz to 1 kHz
Intermodulation Distortion (IMD) 60 Hz and 7 kHz
at 4:1, from full rated output to –30 dB
Damping Factor (8 ohm): 10 Hz to 400 Hz
Operation Manual Mode d'emploi
Amplificateurs de puissance
6 Technische Daten
XLS 202 XLS 402 XLS 602 XLS 802
-- -- --
300W 450W 600W 800W*
200W 300W 380W
600W 900W 1,200W 1600W
-- -- --
*750W for
models
1.25
+0 dB, –1 dB
> 100 dB
> 95 dB
< 0.5%
< 0.3%
> 200
Bedienungsanleitung
Leistungsendstufen Amplificadores de potencia
6 Especificaciones
XLS 5000
Crosstalk (below rated power)
at 1 kHz
at 20 kHz
Input Impedance (nominal) (balanced,
unbalanced)
Load impedance
Stereo
Bridge mono
--
2500W**
1800W*
AC Line Voltage and Frequency Configu-
500W
1100W*
rations Available (± 10%)
3,600W*
--
5,000W**
100V *with 0.1% THD
Ventilation
**with 1% THD
Cooling
Air Volume Requirements (per minute
per unit)
Dimensions: Width, Height, Depth
Net Weight, Shipping Weight
Manual de Operación
–75 dB
–50 dB
20 kilohms, 10 kilohms
4-8 ohms
8 ohms
120 VAC 60 Hz
100 VAC 50/60 Hz
220 VAC 50 Hz
230-240 VAC 50 Hz
Flow-through ventilation from front to back
Luftstrom von Front zu Rückseite
Ventilación de circulación de flujo del frente hacia atrás
Internal heat sinks with forced-air cooling
Interne Kühlrippen mit Zwangskühlung
Disipadores de calor internos con enfriamiento de aire
forzado
3 3
80.15 ft (2.27 m )
XLS 202, 402, 602, 802: EIA Standard19"W (EIA RS-310-B)
x 3.5" (8.9 cm) H x15.2" (38.6cm) D.
XLS 5000: EIA Standard19"W (EIA RS-310-B), 5.25" ( 13.3
cm) H x 15.5" (39.5 cm) D.
EIA Standard 19" Breite (EIA RS-310-B)
Estándar EIA 19"de ancho (EIA RS-310-B)
XLS 202: 23.0 lb (10.4 kg), 28.0 lb (12.7 kg)
XLS 402: 25.7 lb (11.7 kg), 30.7 lb (13.9 kg)
XLS 602: 29.0 lb (13.2 kg), 34.0 lb (15.4 kg)
XLS 802: 35.5 lb (16.1 kg), 40.5 lb (18.4 kg)
XLS 5000: 62.0 lb (27.7 kg), 74.0 lb (33.6 kg)
page 25