Specifi Cations - Crown XLS 202 Operation Manual

XLS Series Power Amplifi ers
7 Specifi cations
Minimum Guaranteed Power (watts)
120 VAC, 60 Hz Units, per channel, both channels driven
1 kHz with 0.1% THD
Stereo, 2 ohm (per ch.)
Stereo, 4 ohm (per ch.)
Stereo, 8 ohm (per ch.)
240 VAC, 50 Hz Units, per channel, both channels driven
1 kHz with 0.1% THD
Stereo, 2 ohm (per ch.)
Stereo, 4 ohm (per ch.)
Stereo, 8 ohm (per ch.)
Performance
Sensitivity (volts RMS)
for full rated power at 4 ohms
Frequency Response (at 1 watt) 20Hz - 20kHz
Phase Response (degrees at 1 watt)
at 10 Hz
at 20 kHz
Signal to Noise Ratio (20 Hz to 20 kHz)
A-weighted, below rated power
No weighting, below rated power
Total Harmonic Distortion (THD)
at full bandwidth power, from 20 Hz to 1 kHz
Intermodulation Distortion (IMD)
60 Hz and 7 kHz at 4:1, from full rated output to –40 dB
Damping Factor (8 ohm) 10Hz to 400Hz
Crosstalk, below rated power
at 1 kHz
at 20 kHz
Input Impedance
nominally balanced, nominally unbalanced
Load Impedance (rated)
Note: Safe with all types of loads.
Stereo
Bridge-Mono
Voltage Gain (at maximum output)
AC Line Voltage and Frequency Confi gurations Available (±10%)
Operation Manual
XLS202 XLS402
250 570
200 400
145 260
260 610
225 445
155 275
XLS202 XLS402
0.725 1.025
± 0.75 dB ± 0.75 dB
–10 –10
+19 +19
> 100 dB > 100 dB
> 97 dB > 97 dB
< 0.15% < 0.15%
< 0.3% < 0.3%
> 200 > 200
–82 dB –82 dB
–58 dB –58 dB
20 k ohms, 10 k ohms 20 k ohms, 10 k ohms
2-8 ohms 2-8 ohms
8 ohms 8 ohms
31 dB 31 dB
120 VAC/60 Hz and 230 VAC/50 Hz 120 VAC/60 Hz and 230 VAC/50 Hz
XLS602
840
600
370
880
670
400
XLS602
1.26
± 0.75 dB
–10
+19
> 100 dB
> 97 dB
< 0.15%
< 0.3%
> 200
–82 dB
–58 dB
20 k ohms, 10 k ohms
2-8 ohms
8 ohms
31 dB
120 VAC/60 Hz and 230 VAC/50 Hz
page 13