Step Four: Check And Test Completed Assembly - North Star Proven Performance M268197C Owner's Manual

Step Four: Check and test completed assembly

Serious injury could result from chemical leaks if sprayer is improperly assembled or
the design of the sprayer is modified.
Follow the steps below to make sure the sprayer is properly assembled. Never modify
the sprayer design.
1. Che ck assembly
2. Fill tank with
water
Assembly
WARNING
Check and test completed assembly
Che ck assembly to make sure the spraye r is prope rly assemble d and in
safe working condition:
a) Check that the gun clip screws are tight, hose clamps are secure, and tank
straps are properly fastened.
b) While it is unlikely that factory assembled components become loose, they
should also be checked to make sure they are tight.
Te st the system for leaks with wate r:
a) First read the instructions in this Owner's Manual for Operation of the
sprayer.
b) Fill the tank with water per the instructions in this manual. Important: The
sprayer should NOT be running when you fill the tank.
c) Check for leaks throughout the system by operating the sprayer per the
instructions in this manual:
i) T urn the sprayer ON. (See Operation Instructions)
ii) Operate the spray gun. (See Operation Instructions)
iii) Adjust the pressure through its full range – to maximum and back.
(See Operation Instructions)
d) If a leak is detected, fix the leak and re-test the system with water.
13