Toro TimeCutter SS 4235 Operator's Manual page 36

Note: Avoid placing the supports under any anti-scalp
rollers if present on the deck.
7. Move to the left side of the machine. Check if the side
carriage bolt is in the fixed or slotted position (Figure
49).
5
3
4
Figure 49
1. Hanger bracket
2. Slotted adjustment
position
3. Fixed position
8. If the side carriage bolt is in the fixed position, remove
the side carriage bolt and side locking nut from the
fixed position and install it into the slotted adjustment
position (Figure 50).
If the bolt is in the slotted position, the carriage bolt
and side locking nut do not need to be removed.
5
3
4
Figure 50
1. Hanger bracket
2. Slotted adjustment
position
3. Fixed position
9. Loosen the rear locking nut on the hanger bracket just
enough to move the bracket (Figure 51).
G015323
1
2
4. Side locking nut
5. Side carriage bolt
G015323
1
2
4. Side locking nut
5. Side carriage bolt
3
4
1. Hanger bracket
2. Rear locking nut
10. Use the notches on the welded bracket to measure
the amount of adjustment. Each notch surface is
equivalent to 0.25 inch , while a single side is 0.125
inch (Figure 52). Adjust the height of the mower deck
to the desired height.
1
2
1. 0.25 inch
11. Stop the deck at the adjusted position and tighten the
rear locking nut on the hanger bracket to hold the new
position (Figure 51). Tighten the side locking nut on
the hanger bracket.
12. Continue leveling the deck by checking the front-to-rear
blade slope; refer to Adjusting the Front-to-Rear Blade
Slope.
Adjusting the Front-to-Rear Blade
Slope
Check the front-to-rear blade level any time you install the
mower. If the front of the mower is more than 5/16 inch
(7.9 mm) lower than the rear of the mower, adjust the blade
level using the following instructions:
36
1
2
G015324
Figure 51
3. Side locking nut
4. Adjustment notches
G015325
Figure 52
2. 0.125 inch