Sony CCD-F35 Service Manual page 232

side waveform flat by turning the No. 6 guide (TG-6) @.
Note: Take care not to loosen lockscrews too much, since
guides come loose easily. «
SV-34 board (GV-8)
{ SV-35 board (GV-8E)
Method for signal output:
Short-circuit pin © (GND) and pin @ (RF SW.P)
of CNO18 on the
SV-34 board (GV-8)
{ SV-35 board (GV-8E)
3) Play back the alignment tape for tracking adjustment (Ref.
No. J-5).
4) Confirm that both the entrance and exit side RF waveforms
of the oscilloscope are flat (See Fig. 4-4). If they are not,
adjust as follows.
SV-34 Board (GV-8) )
'SV-35 Board (GV-8E)
'Should be flat.
eae
Fig. 4-4.
—30—