Drum Assembly, Dew Sensor - Sony CCD-F35 Service Manual

3-13. DRUM ASSEMBLY, DEW SENSOR
1. Removal (See Fig. 3-14.)
1) Set the EJECT) mode.
2) Remove the flexible board @ and the two connectors @ .
3) Remove the guide guard assembly as described in section
3-2.
4) Remove the screw @ , then remove the axle ground
terminal @ .
5) Remove the three screws @ , then remove the dum
assembly @ from the mechanism chassis.
6) Remove the connector @
7) Remove the screw @, then remove the dew sensor@.
Note: ¢ When removing the drum assembly @ from the
mechanism chassis, take care not to cut the flexible
board @ or the hamess.
© Take care not to touch the head tip @ .
2. Installation (See Fig. 3-14.)
1) _ Insert part @ of the dew sensor @ into the notch @ of the
mechanism chassis, then secure it with the screw @.
2) Mount the connector @.
3) Clamp the hamess @® of the dew sensor @ with the
teinforcing the claw @® of the plate SS assembly (See
Fig. A).
4) Insert the connector @ and the flexible board @ into the
hole @® of the mechanism chassis, align the drum assembly
@ with the two dowels @ and secure it with the three
screws @.
5) Align the axle ground terminal @ with the two dowels @ of
the mechanism chassis and secure it with the screw @.
6) Mount the guide guard assembly as described in section 3-2.
7) Mount the two connectors @ and the flexible board @.
Note: © Take care not to cut the flexible board @ or the
hamess ®.
© Take care not to touch the head tip @ .
© After assembling, be sure to perform Tape Path
Adjustment following instructions in section 4.
YX
3
@ Axle Som
Terminal te
@ Screw (P1.4 x 1.8)
@® Connector
+
© Screw (P2 x 3)
© Drum Assembly
WB, Chae
— 18 —