Wheels; Body And Deck - Scag Power Equipment SFC30-7CV Operator's Manual

R

7.7 WHEELS

The rear drive wheels should be removed and any debris
cleaned from the wheel gear area after every 40 hours of
operation or weekly, whichever comes first.
- NOTE -
In extremely dusty conditions it may be necessary
to clean the wheels more frequently than
recommended to prevent wheel damage and
increase gear life.
To prevent damage to the wheel bearings, do not
use high-pressure water to clean the wheels.
1. Remove the rear wheels and clean any debris from
the wheel area.
2. After cleaning the wheels, apply a small amount of
anti-seize lubricant to the gears.
GEAR
Figure 7-8. Rear Wheels

7.8 BODY AND DECK

CAUTION
Do not wash any portion of the equipment while it
is hot. Do not wash the engine; use compressed
air.
1. After each use, wash the mower and cutter deck.
Use cold water and automotive cleaners. Do not use
pressure cleaners.
2. Do not spray electrical components.
3. Repair damaged metal surfaces using Scag touch-
up paint available from your authorized Scag dealer.
Wax the mower for maximum paint protection.
36
Section 7