Wheels; Body And Deck - Scag Power Equipment SFC-21-4GX Operator's Manual

Section 7
5. To install the new cutter blade, put the flatwashers
onto the blade bolts, and install the bolts into the
holes in the cutter blade.
CUTTER BLADE
FLATWASHER
3/8-16 x 3/4" HEX HEAD BOLT
TORQUE TO 39 FT/LBS
Figure 7-6. Blade Replacement
- NOTE -
Be sure that the blade is installed with the lift wing
toward the top.
6. Install the cutter blade onto the the machine. Secure
the blades from rotating and torque to 39 ft/lbs.
See Figure 7-6.

7.12 WHEELS

The rear drive wheels should be removed and any debris
cleaned from the wheel gear area after every 40 hours of
operation or weekly, whichever comes first.
- NOTE -
In extremely dusty conditions it may be necessary
to clean the wheels more frequently than
recommended to prevent wheel damage and
increase gear life.
To prevent damage to the wheel bearings, do not
use high-pressure water to clean the wheels.
1. Remove the rear wheels and clean any debris from
2. After cleaning the wheels, apply a small amount of
FLATWASHER

7.13 BODY AND DECK

1. After each use, wash the mower and cutter deck.
2. Do not spray cold water on the engine, clutch or
3. Repair damaged metal surfaces using Scag touch-
31
the wheel area.
anti-seize lubricant to the gears.
GEAR
Figure 7-7. Rear Wheels
CAUTION
Do not wash any portion of the equipment while it
is hot. Do not wash the engine; use compressed
air.
Use cold water and automotive cleaners. Do not use
pressure cleaners.
electrical components.
up paint available from your Authorized Scag Power
Equipment Dealer. Wax the mower for maximum
paint protection.
R