Troubleshooting - Philips FB 206W Instructions For Use Manual

TROUBLESHOOTING
WARNING
If a
fault occurs, first check the points listed below before
taking the speakers for repair.
Under no circumstances should you try to repair the
speakers yourself, as this will invalidate the If You are unable to solve a problem by following these hints,
guarantee. consult your dealer or service centre.
PROBLEM
POSSIBLE CAUSE
SOLUTION
No sound
VOLUME is not correctly adjusted.
Adjust the VOLUME.
Headphones are connected to the appliance.
Disconnect headphones.
Speakers are not (or wrongly) connected.
Connect the speakers securely.
No sound on the
One speaker is wrongly connected.
Connect the speaker properly.
left or right side
A speaker cable is damaged.
Replace the cable.
Poor sound or no sound at SURROUND mode is not switched on.
Switch to the surround mode on the appliance.
the centre or surround
speakers
Surround and/or centre speakers are not
(properly) connected.
Connect the speakers properly.
A speaker cable is damaged.
Replace the cable.
Transmitter unit or active surround speakers
are switched off.
Switch on transmitter and active surround
speaker.
Transmitter unit and/or active surround
speaker are not securely connected to the
mains.
Connect the mains cables properly.
CHANNEL switch of the transmitter unit and
the active speaker are not switched to the
same number.
Set the CHANNEL slides on the transmitter unit
and on the active speaker to the same number.
Transmitter unit is connected to the wrong
output on the appliance.
Connect the transmitter unit to the correct
terminal on the appliance.
SURR/MULTI switch of the transmitter unit
is in the wrong position.
Set the SURR/MULTI switch to the SURR
position.
The signal from the transmitter unit is
interfered through electric appliances.
Set the transmitter unit and the active
surround speaker to another transmitting
channel.
The signal from your appliance is too strong.
Set the input sensitivity of the transmitter, unit
to the next level.
Poor bass sound
Speakers are not in phase.
Connect speakers properly; coloured cable to
©-pole, black cable to ©-pole.
Bad sound
Badly matching setting for the given type of
music or sound.
Correct the sound settings on the appliance.
Surround sound level is
too low or too high
The level of the surround sound is not
properly adjusted.
Adjust the level and delay time of the
surround sound on the appliance.
Centre sound level is too The sound level of the centre channel is not Adjust the level of the centre channel
low or too high properly adjusted. on the appliance.
9