BenQ W700 Product Service Manual page 66

Auto Keystone Function
Auto Keystone Calibrate Adjust Procedure
Step 1 : Confirmed the full set is already.
Step 2 : Turn on the Projector.
Step 3 : From keypad, You can enter service mode by press the "MENU" key
firstly and press (Enter + Source) keys together at the same time.
Step 4: If password is correct then go into Service Mode.
Step 5 : Adjust the "adjustment foot" of the projector, confirm the "adjustment foot"
already adjusts to the bottom nearly. Make it to put the projector on a
stability Horizontal tabletop. (0°±1°).
Step 6 : Into runs the service mode, after ready press the "A/K Calibration" item to
Note:
In order to shake to the projector while pressed according to the "Enter" key,
Please use the remote controller to operate while in the "Step 4".
act the Auto Keystone Calibrate
66