Kenwood TS-830S Instruction Manual page 6

Headphones
Use headphones of 4 to 160
impedance. The optional HS-4, HS-5
headphone is best suited for use with
the TS-830S. Stereo-type headpho-
Microphone
Either a low or high impedance
microphone (50022 to 50 k®) can be
used. The P.T.T. switch should be
isolated from the mic circuit (shown
in "A"). Use a microphone with a
separate switch and MIC line so both
P.T.T. and VOX are available.
nes can also be used.
he Transcever J
A
Transformer
Microphone ) € 3] ;
View from cord side
Ae) this $ Switch
Transformer
Microphone |) © 3 g § Switch
{b) not this Microphone connection
E07-0403-05
Microphone )) e 3
Transformer Switch c
ee 10K ~ 33 K
(c) not this
F x TS-830S
Microphone ° Microphone connector
Antenna
Key External speaker
1) Monitor scope
For CW operation, connect your key SM-220 Besides the built-in
to the KEY jack at the rear. Use Can be used for speaker, an external
shielded cable. RX monitor, pan speaker can also be used.
Lightning display, and TX Connect to the rear EXT
arrestor _ monitor. SP jack using the supplied
plug.
GND terminal
It is recommended that a ground
lead be connected to the GND ter-
minal at the rear of the set to prevent
the possibility of electric shock, TVI
and BCI. Use as short, and heavy a
lead as possible.
VFO-230
Linear amp
Power supply
Transverter
120V 50/60 Hz
External VFO
Fig. 2-1 TS-830S Connections