Kenwood TS-830S Instruction Manual page 26

@ EXTENSION FEET
The TS-830S is provided with two extension feet which can
be used to elevate the front panel. In some operating
positions the tilt makes it easier to read the dial and meter.
Fig. 5-6 shows how to install the feet.
Fig. 5-6 Attaching the Extension Feet |
@ OPERATION WITH A SEPERATE RECEIVER
ANTENNA
Use the XVRTR port and an 8 Pin DIN Plug, Part E07-0851-
05
Pin 8 HF Ant output from the TS-830S
Pin 5 RX Ant input
Pin 3. GND
Pin5
' Nor o—_______> Pin8
Pin 8 HF Ant output from the TS-830S
Pin 5 RX Ant input
Pin 3. GND
Pin 2. RL control, 12V DC in TX
Connect pins 8 and 5 together and through a short length of
50 coax to your second receiver Ant input.
Use pin 2 to mute the second receiver in TX.
26
Use the ACSY Connector. Pin 3 (PTT line) to your XMTR
control output, to ground connect Pin 3 in TX Connector
metal shell Ground Feed the antenna through the primary
XCVR/XMTR Relay.
@ OPERATION WITH THE SM-220 SCOPE AND
BS-8 AN DISPLAY
No modifications or wire changes are required. Cable as
follows:
TS-830S to SM-220
IF#1 Rear panel IF Input
IF#2 Verticle Input