Operation Procedure; Opening/Closing The Cover Door - JUKI AW-3SD Instruction Manual

3. OPERATION PROCEDURE

WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.

3-1. Opening/closing the cover door

It is necessary to open cover door ❶ on the top of the table to set up a bobbin in the device. When you want
to open cover door ❶ , twist switch ❷ on the front face of the sewing machine by hand in the direction of the
arrow in the figure. Then, the end portion of the cover door goes up from the top of the table. Remove cover
door ❶ holding its end portion with your hand.
To close cover door ❶ , insert protruding portion ❸ of cover door ❶ until it comes in contact with the table
opening section and release your hand from it. Cover door ❶ is closed by twisting switch ❷ in the opposite
direction of the arrow in the figure.
Be sure to close cover door ❶ for the sake of safety whenever you carry out sewing.
In addition, if cover door ❶ is not closed securely, the sensor will detect that the door is in
the opened state to disable starting of sewing.
It should be noted, however, origin retrieval and inching operation are allowed to start. So,
be careful.
❶
❶
– 5 –
❷
❸