Connectionsof Audio Andvideocomponents(Kr-897); Connectionsof Audio And Videocomponents(Kr-797) - Kenwood KR-897 Instruction Manual

_7/K_797 JEt
Connections ofAudioand Videocomuonents (KR-79 7 )
Make connection as shown below.
When connecting the related system components, refer
also to the instruction manuals of the related compo-
nents.
/k Do not plug in the power lead until all connections are
completed.
I Malfunction of microcomputer .
If operation is not possible or erroneous display appears even
though all connections have been made properly, reset the micro-
computer referring to "In case of difficulty'. -[_.
!
OUT
Audio
IN
Video deck 1, cassette deck 1
or MD recorder
KX-W597/KX-W797 .1
Video deck 2 or DVD/LD I_layer
-1 System
control cord
*2 Cassette deck 2
• Do not connect up a
power source which is
larger than that indi-
cated on the socket at
the rear of the unit.
%
System control cord
Turntable
Multipul CD player
DP-R797
-1 The system control cord should be connected when a
KENWOOD aud o component system is connected.
*2 Do not connect system control cord to the cassette
I
I deck connected to the TAPE 2 MONITOR jacks, t
*3 The KX-W797 and KM-897 are not marketed in other I
areas than the USA and Canada.
I
Caution regarding placement
(Except for U.S.A. and Canada)
To maintain proper ventilation, be su re to leave a space around the
unit (from the largest outer dimensions including projections)
equal to, or greater than, shown below.
Left and right panels : 10 cm
Rear panel : 1Ocm
Top panel : 50 cm