Recordin - Kenwood KR-897 Instruction Manual

KR-BS7/K_7S7 IEn|
When recording sound with a recorder component of KENWOOD, synchro recording is possible by setting the INPUT SELECTOR
to select TAPE1 or MD according to the connected component.
I Preparation
eSwitch the TAPE1 display to MO or VIDE01 with the following Each press switches the display.
operation."
O Select TAPE1 with the INPUT SELECTOR. I
T
(_ PressandholdtheAUTOkeyformorethan2seconds. _LTAPE1 -_ _MD -'- ,._VIDEO1
Torecord a music source
Select the source to be recorded.
It4PMT ,_E LIECT]DR
TAPE1.
(_ Put the cassette deck in record-pause
mode.
e Play the source and start recording.
The input sources are switched in the following order:
I _TUNER (frequency display)
PHONO
_TAPE1 (MD or VIDE01)
c D
VIDEO2
• The VIDEO1 display can be switched to the display of other input by
using the procedure described in "Preparation" above.
• For the synchro recording with a cassette deck and/or MD recorder.
refer to the respective instruction manuals..
• It is not possible the VIDE01 or MD input to TAPE1 because all of these
components should use the same INPUT SELECTOR position.
Copying tape (Tape dubbing TAPE2-* TAPE 1)
O Press the TAPE 2 MONITOR key.
_o _v _MN_ T_2
O II I i _ i
Select a source other than TAPE 1.
R_atJT SELECTOR
0 Play cassette deck 2 and start recording
on cassette deck t.
Lights
.tJ
• For copying a tape using a double cassette deck. read the instruction
manual of the double cassette deck.
Copying tape (Tape dubbing TAPE 1:+ TAPE2)
!_ Select TAPE 1 with the INPUT SELECTOR control of the
"P::iY:_:i_assette deck €onnected to the TAPE 1 jacks and
Regarding TAPE2 MOMTOR
A cassette deck or graphic equalizer can be connected to this unit's TAPE 2 MONITOR terminals. If you connect a graphic equalizer, turn the
TAPE 2 MONITOR key ON. If you connect a 3-head cassette deck. you can monitor the source sound, or the sound being recorded, while
recording. Pressing the TAPE 2 MONITOR key lets you compare the recorded sound and the source sound. Refer to the operating manual for
the component you connected for further details.