Table of Contents
Advertisement
CONNECTmNG EXTERNAL
VmDEO SOURCES
The exact arrangement
you use to connect the VCR, camcorder, laserdisc player, DVD player, or HDTV Set Top Box to your TV set is
dependent on the model and features of each component.
Check the owner's manual of each component for the location of video
and audio inputs and outputs.
The following connection diagrams are offered as suggestions.
However, you may need to modify them to accommodate
your
particular assortment of components
and features.
For best performance, video and audio cables should be made from coaxial
shielded wire.
Before Operating
Externam Video Source
The input mode is changed every time the VIDl--VID5
button is pressed as shown below. Connect an external source to the INPUT
terminal, then press the VIDI-VID5
button as necessary to view the input source (see page 22).
NOTE:
INPUT MODE SELECTION
ORDER
(ANTENNA)
(INPUT}
AntA
YPBP_;1
When the TV is set to VUDEO and a video signal is not received from the VDEO INPUT JACK on the back panel of the
TV (Le, VCR/laserdisc
player, etc. is not connected or the video device is OFF), the set will appear to be OFF.
J
14
Advertisement
Table of Contents
