Installation Instructions
STEP 5| SLIDE UNIT INTO ENCLOSURE
Roll the unit into the enclosure, being careful not to pinch
the water line or power cord.
S.
Q
oo
SL
ON
* Along flat bar or yard stick may be needed to guide the
front edge of the anti-tip bracket over the unit.
* |f space allows, you may also bend the front edge of the
bracket upward slightly, allowing it to clear the back of
the unit.
* Remove Top-Center trim cover from unit.
e Secure the unit to the Anti-tip bracket using both
machine screws & washers to engage the threaded
inserts in the anti-tip bracket.
« Hand start the screws until unit is in desired location
within the install space.
* Finalize unit install by tighening the screws fully.
* Reinstall Trim cover.
15
STEP 6 | REMOVE TOEKICK AND VENT
The toekick must be removed to access
the leveling leg system.
e Remove band around EPS block in front of toekick.
e Remove and dispose of EPS block.
# Remove the solid portion of the toekick by pulling forward.
* Place the toekick, vent and screws out of the way so you
will have them for reinstallation.
Vent
|
Screws
Vent
(behind
ep aa
SS ee ee
:
——
toekick}
= S555 Se22== O)!| —
Screw
Screw
—~
Toekick