Advertisement
and
AM(Mw/Lw)
Antennas
COAXL_L
(supplied)
If FM reception is poor,
_FFM
(not supplied).
Antenna (supplied)
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop antenna,
Cooling fan (See "About Cooling Fan" below.)
1. Connect the FM antenna supplied to the FM 75Q
COAXIAL terminal as temporary measure.
2. Slowly move the antenna wire around until you
find a location where reception is good, then
fasten it to a wall or other rigid surface.
1. Connect the AM loop antenna supplied
to the AM and _ terminals,
2. If reception is poor, connect an outdoor
single vinyl-covered wire to the AM
terminal. (Keep the AM loop antenna
connected).
A cooling fan is mounted on the rear panel of the center unit to
preventabnormal temperatureinside the center unit, thus assuring
normal operation. The cooling fan automatically starts rotating to
supply external cool air to the inside of the center unit when the
internal temperature exceeds the specified limit,
For safety, observe the following carefully.
• Make sure there is good ventilation around the center unit. Poor
ventilation could overheat end cause damage,
• DO NOT blockthe cooling fan and the ventilation openingsor
holes, (If they are blocked by a newspaper or cloth, etc., the heat
may not be able to escape.)
14
Advertisement
