Wacom Intuos3 12x19 User Manual page 62

Double-clicking is difficult.
The pen selects
everything, will not stop
drawing.
The eraser selects
everything or will not stop
erasing.
You notice a delay at the
beginning of pen strokes.
You have to press hard
with the pen when clicking
or drawing.
The pen tip does not
function.
Changing the function
settings for the Intuos3
tools has no effect.
C
ONTENTS
Be sure you are quickly tapping the tablet twice in the same place on the
tablet's active area.
Using the side switch to double-click is recommended (review the
techniques in clicking). See also
Set one of the ExpressKeys to D
clicks.
Try increasing the T D
IP
double-click).
Try using a lighter T F
IP
Windows: Try setting your system to launch programs with a single click.
See clicking.
Open the Wacom Tablet control panel and go to the P
F slider toward F
EEL IRM
C T setting. If this does not help, see
LICK HRESHOLD
Open the Wacom Tablet control panel and go to the E
E F slider toward F
RASER EEL
increase the C T
LICK HRESHOLD
your tools.
Try decreasing the T
IP
double-click). If that does not work, try dragging the T
D slider to the O
ISTANCE
Open the Wacom Tablet control panel and go to the P
F slider toward S
EEL OFT
S and C
ENSITIVITY LICK
Make sure the status LED changes from blue to green when the tip is
pressed. If it does not, you may have defective hardware (see
tools).
Check the control panel's P
C function.
LICK
Make sure that you change the settings for the tool and the application that
you are using. See working with multiple tools
specific settings.
C
ONTENTS
I
NDEX
adjusting tip feel and
C
OUBLE LICK
C D
OUBLE LICK ISTANCE
(see adjusting tip feel and
EEL
, or select the D
ETAILS
, or select the D
IRM
setting. If this does not help, see
D C D
OUBLE LICK ISTANCE
position in order to turn off double-click assist.
FF
, or select the D
ETAILS
T settings
HRESHOLD
tab and verify that the tip is assigned to a
EN
I
NDEX
T
ROUBLESHOOTING
double-click.
and use it to issue double-
(see adjusting tip feel and
double-click).
tab. Move the T
EN
... button and increase the
testing your tools.
tab. Move the
RASER
... button and
ETAILS
testing
(see adjusting tip feel and
D C
IP OUBLE LICK
tab. Move the T
EN
... button and decrease the
testing your
and working with application-
62
IP
IP
62