Table of Contents
Advertisement
RX-SO8VBK
RX-508VBK
;
RX-509VTN
i
RX-SO9VTN
Installation
This section explains how to connect the receiver to other stereo equipment and speakers, and
Connecting Stereo Components
how to connect the power supply.
Before Starting
You can connect the following components to the receiver:
ES Gouons
i
Audio components
+ Tumtable
Before installation
4X CAUTION! Before installing your receiver:
!
+ CD player
© Make sure yout tons are dry.
+ Two tape decks
© Turn the power off to all components.
:
© Read the installation instructions for all components you are going to connect.
Video wae
Positioning the Receiver
A\ CAUTION!
: _— disc player
© Install the receiver in a location thot is level and protected from moisture.
. tere
around the receiver must be between 23° and 104° F (-5°
and
40° C).
IMPORTANT!
.
j
. Nee sure there is good ventilation around the receiver. Poor ventilation
lof r ee,
log derpresp st Shoe ubipgtoatvor acd i
could
cause overheating and dat
the receiver.
Amina
|
ing
image
if they are reversed, the stereophonic image will not be correct.
i
UTION!
pena fone
a
"
|
NOTE: To ensure correct connections, insert the red plug into the right channel.
nnesnons:
* Do not handle the power cord with wet hands.
'
* Do not pull on the power cord to unplug the receiver. Always grab the plug
:
directly so as not to damage the cord.
!
Basic Connections
Connect stereo components to the amplifier using cables with RCA PIN plugs. If you are
.
7
i
for Audio Equipment
connecting a tape deck, connect the output jacks on the tape deck to the jacks marked IN
Handling the Receiver
4 CAUTION!
(PLAY) on the receiver, and the input jacks to those marked OUT (REC).
© Do not insert any metal object into the receiver.
© Do not disassemble the receiver or remove screws, covers, or cabinet.
NOTES:
;
©
Do not expose the receiver to rain or moisture.
i
«
Any aurniables incorporating a small-output cartridge such as an MC (moving-coil
type) must be connected to this amplifier through a commercial head amplifier or
step-up transformer. Direct connection may result in insufficient volume.
¢
Ifa ground cable is fitted to your turntable, connect
the cable to the screw marked
GND on the rear panel.
CD PLAYER
TAPE DECK 1
Page 4
Page 5
1-6 (No. 20376)
(No. 20376) 1-7
Advertisement
Table of Contents
