Table of Contents
Advertisement
To choose linked channel mode
1. Press PM3 to display the Utility Menu.
2. System Utilities will be on the bottom line of the
screen. Press PM1 to select.
3. Rotate PM1 until Linked Channel Mode appears on
the bottom line of the screen. Then press PM1.
4. To change the setting for inputs, rotate PM2 to
choose INP= ON or OFF. You can only edit this setting
if inputs are linked.
5. To change the setting for outputs, rotate PM3 to
choose OUT= ON or OFF. You can only edit this
setting if the outputs are linked.
6. Press PM2 to return to the System Utilities menu.
7. If you've finished, press PM2 twice to exit the menu
system.
Recall mode
Recall mode allows you to choose whether to keep the
current channel mute status when you recall a preset.
When switched off, the channel mutes will use the
settings in the recalled preset. When switched on, the
channel mutes will be unchanged when you recall a
preset.
You can use this setting to avoid a sudden burst of high-
volume sound when you recall a preset. To do this, make
sure Recall mode is ON and mute the channels before you
recall a preset.
To change the recall mode
1. Press PM3 to display the Utility Menu.
2. System Utilities will be on the bottom line of the
screen. Press PM1 to select.
3. Rotate PM1 until Recall mode appears on the bottom
line of the screen. Then press PM1.
13
4. To use the current mute status rather than the preset
mute status when you recall a preset, rotate PM2 to
ON.
To use the mute settings in the preset when you recall
a preset, rotate PM2 to OFF..
5. Press PM2 to return to the System Utilities menu.
6. If you've finished, press PM2 twice to exit the menu
system.
Set factory value
This sets all input and output channels back to the default
factory settings. This does not impact settings such as
network settings, passwords and user settings.
To set inputs and outputs to factory settings
This will delete all your input and output
channel settings. You may want to back
up or note your settings before you do
this.
1. Press PM3 to display the Utility Menu.
2. System Utilities will be on the bottom line of the
screen. Press PM1 to select.
3. Rotate PM1 until Set factory value appears on the
bottom line of the screen. Then press PM1.
4. If you are sure this is the right thing to do, press PM1
to confirm.
5. Press PM2 to return to the System Utilities menu.
6. If you've finished, press PM2 twice to exit the menu
system.
Prevent output clip
The processor has a built-in clip limiter to prevent any of
the outputs clipping. This is switched on by default. You
can switch the clip limiter on or off as required.
DX0.6 User Guide
Advertisement
Table of Contents
