E - Maintenance; Servicing - Lincoln Electric WELDYSTIFFENER Safety Instruction For Use And Maintenance

E - MAINTENANCE

1 - SERVICING

 So that the machine continues to provide good service for as long as possible, a certain minimum of care and
maintenance is necessary
 The frequency of this maintenance work is given on the basis of the production of one work station per day.
Maintenance should be more frequent if production is greater.
Your maintenance department may photocopy these pages so that it can follow up maintenance dates and
Remove regularly welding projection on protection lenses of the photo cell, protection casing and
support roller.
Regularly clean the outside of the carriage and the welding torch support adjusting elements.
Date of maintenance :
- Grease manœuvre screw
- Dismount and clean the support rollers.
Date of maintenance :
- check up the transmission system
- adjust the clearance of guiding shims on the slides
- adjust the clearance of the geared motor on the large sprocket wheel.
- wash and grease the wheels.
- blow very carefully the electronic card, speed regulator, electric rack.
E-14
operations (tick as appropriate)
Every 100 hours
/ /
Annually or after every 500 hours
/ /
Daily
8695 5876 / E
WELDYSTIFFENER