ASROCK EC262D4U-2L2T User Manual page 64

Bits Per Second
Use this item to select the serial port transmission speed. The speed used in the host
computer and the client computer must be the same. Long or noisy lines may require lower
transmission speed. The options include [9600], [19200], [38400], [57600] and [115200].
Data Bits
Use this item to set the data transmission size. The options include [7] and [8] (Bits).
Parity
Use this item to select the parity bit. The options include [None], [Even], [Odd], [Mark] and
[Space]. A parity bit can be sent with the data bits to detect some transmission errors.Mark
and Space Parity do not allow for error detection. They can be used as an additional data
bit.
Even: parity bit is 0 if the num of 1's in the data bits is even.
Odd: parity bit is 0 if num of 1's in the data bits is odd.
Mark: parity bit is always 1.
Space: Parity bit is always 0.
Stop Bits
The item indicates the end of a serial data packet. The standard setting is [1] Stop Bit. Select
[2] Stop Bits for slower devices.
Flow Control
Use this item to set the flow control to prevent data loss from buffer overflow. When
sending data, if the receiving buffers are full, a "stop" signal can be sent to stop the data
flow. Once the buffers are empty, a "start" signal can be sent to restart the flow. Hardware
flow uses two wires to send start/stop signals. The options include [None] and [Hardware
RTS/CTS].
VT-UTF8 Combo Key Support
Use this item to enable or disable the VT-UTF8 Combo Key Support for ANSI/VT100
terminals.
Recorder Mode
Use this item to enable or disable Recorder Mode to capture terminal data and send it as
text messages.
Resolution 100x31
Use this item to enable or disable extended terminal resolution support.
Putty KeyPad
Use this item to select Function Key and Keypad on Putty.
56