Sony RDR-HX900 Operating Instructions Manual page 27

"16:9": For wide-screen TVs or standard TVs
with a wide screen mode.
For details, see "TV Type" on page 87.
18Press
ENTER.
The Setup Display for selecting the type of
jack used to connect to your amplifier
(receiver) appears.
EASY SETUP Audio Oonnection 7,7
Is t_is re_order _onnected to all amplifier _recei,er)?
Selct ihe i_pe of jack yoJ are Lsin_
Yes LINE OUTt_R AUDIO L)
19Select
the type ofjack (if any) you are
using to connect to an amplifier (receiver),
and press ENTER.
If you did not connect an AV amplifier
(receiver), select "No," then go to step 23.
If you connected an AV amplifier (receiver)
using just an audio cord, select "Yes: LINE
OUT (R-AUDIO-L)," then go to step 23.
If you connected an AV amplifier (receiver)
using either a digital optical or coaxial cord,
select "Yes: DIGITAL OUT."
20Select
the type of Dolby Digital signal you
wish to send to your amplifier (receiver).
;{;% EASY SETUP Auclio Connection 7_7
_)o_b_, , Oigi/al
r ]
Dolb,, Dig_t_ v
21
Press ENTER.
The Setup Display lbr the DTS signal appears.
[ EASY SETUP Auclio Connection 7_7
OTS
on
[-5_ ]
22Select
whether or not you wish to send a
DTS signal to your amplifier (receiver),
and press ENTER.
If your AV amplifier (receiver) has a DTS
decoder, select "On." Otherwise, select "Off."
23Press
ENTER when "Finish" appears.
Easy Setup is finished. All connections and
setup operations are complete.
If you use the cable box, satellite receiver
control, check that the control works correctly
(see below).
EASYSETUP
EasyS et,_p is f_nished
You mnst leave the recorder turned off for
at least 24 hours to receive the TV Guide
On Screen data. If your recorder is
connected to a cable box, be sure to leave
the cable box turned on.
:3:
O
g
==
If your AV amplifier (receiver) has a Dolby
Digital decoder, select "Dolby Digital."
Otherwise, select "D-PCM."
To return to the previousstep
Press d"_ RETURN.
"_° Hint
If you want to nm Easy Setup again, select "Easy Setup"
in tbe Setup Display (page 95).
• To record TV programs using the timel, you must set
the clock accurately.
• If you use an S-video cord to connect your cable box or
satellite receiver, set "Linel Input" or "Line3 Input" in
Video Setup to '% Video" (page 89)
,,_continued
27