Step 5: Connecting The Power Cord; Step 7: Easy Setup - Sony RDR-GX7 Operating Instructions Manual

Connect the supplied power cord to the AC IN terminal of the
recorder. Then plug the recorder and TV power cords into an
AC outlet. After you connect the power cord, you must wait for
a short while before operating the recorder. You can operate
the recorder once the front panel display lights up and the
recorder enters standby mode.
if you connect additional equipment to this recorder (pages 29 to
30), be sure to connect the power cord after all connections are
complete.
to AC IN
to AC outlet
You can control the recorder using the supplied remote, insert
two Size AA (R6) batteries by matching the @ and @ ends on
the batteries to the markings inside the battery compal_ment.
When using the remote, point it at the remote sensor [] on the
recorder.
Follow the steps below to make the minimum number of basic
adjnstments for using the recorder. If you do not complete Easy
Setup, it will appear each time tou turn on your recorder.
Make the settings below in the following order.
]OSD Language Setup J
4
[c,ook Setup]
4
[Tuner and Channel
Setup]
4
[Tv Type Sotup3
4
[Audio Connection Setup]
i ¸ ) @ i ::
RETURN ......
..... t/¢
.....
€-d1"/1/-*,
ENTER
• If the supplied remote interferes your other Sony DVD recorder or
player, change the command mode number for this recorder. For
details, seepage 28.
• Do not leave the remote in an extremely hot or humid place•
• Do not drop any foreign object into the remote casing, particularly
when replacing tl_e batteries.
• Do not expose the remote sensor to direct sunlight or a lighting
apparatus. Doing so may cause a malfunction.
• If you do not use the remole for an extended period of time, remove the
batteries m avoid possible damage from battery leakage and corrosion.
I[! Turn on the TV.
[] Press I/@.
The recorder turns on and the power indicator on the
front panel lights up in green.
[]
Switch the input selector on your TV so that
the signal from the recorder appears on your
TV screen.
"Initial settings necessary to operate the DVD
recorder will be made. You can change them later
using Setup." appears. If this message does not
appear, select "Easy Setup" from "'SETUP" in the
System Menu to run Easy Setup. For details, see
"Settings and Adjustments" on page 90.
2 Step 5: Connecting the Power Cord