2.
Loosen the screw on the upper back of the projector, then pull
back and lift the lamp housing grille from the projector.
3.
Grasp condenser-lamp bracket and pivot about the hinge
(Figure 10).
4.
Release the retaining springs and flip away from the lamp.
5.
Pull lamp from receptacle (Figure 11).
6.
To replace lamp, push into receptacle until firmly seated
making sure that tlie lamp is down against the metal finger
stops and the front face is flat against the mounting bracket.
7.
LOCK LAMP RETAINING SPRINGS IN PLACE.
8.
Swing condenser-lamp bracket into place.
9.
Replace the lamp housing grille.
FIGURE 10
FIGURE 11