Table of Contents
Advertisement
IF SOUND IS BEHIND PICTURE:
With film speed switch in SINGLE position, press the reverse
button until the frame corresponds with the sound.
4.5
Pause
Control
To stop the program for questions and answers or class discussion,
press the PAUSE key. To restart the program, press the PAUSE
key again.
4.6
Finishing the Presentation
1.
When the program is finished, the cassette deck will automati¬
cally shut off or the cassette STOP/EJECT button can be used.
2.
Push the cassette REWIND button. Allow the tape to rewind
completely before again pressing the STOP button.
3.
To rewind the filmstrip, press the film reverse button. Allow
the film to rewind completely before stopping. If the filmstrip
is not engaged in the unit, it must be removed from the lower
film spring.
NOTE: Rewinding of the tape cassette and the filmstrip may be
done simultaneously.
4.
To remove the film, guide remainder of the film back out of
the film carrier. Remove the film roll from the upper film
spring and replace in film container.
5.
To remove the tape cassette, press the STOP/EJECT key. The
top of the cassette will pop out and is easily removed. Replace
tape cassette in its appropriate container.
6.
Push down on the elevation button and retract the legs before
putting the projector in its case.
4.7
Remote Control Operation
The Micromatic II functions as a remote control projector with the
accessory remote control cord (#110-1727A). Plug the (6 Prong)
remote control cord plug into the remote receptacle on the film
control panel. The remote control has manual advance and reverse
capability in the single and fast modes. The remote control cord
comes equipped with a 12 foot cord. If additional cord length is
needed, an accessory 25 foot extension cord (200-468) for the
remote control can be added.
8
Advertisement
Table of Contents
