Specifications - Crown CE Series Operation Manual

7 Specifications

Minimum Guaranteed Power
120 VAC, 60 Hz Units, Stereo mode, per channel, both channels driven
1 kHz with < 0.5% THD
2 ohms
4 ohms
8 ohms
120 VAC, 60 Hz Units, Bridge mono mode
1 kHz with 0.1% THD
4 ohms
8 ohms
Performance
Frequency Response (at 1 watt, 20Hz - 25 kHz)
Phase Response (at 1 watt, 20Hz - 20 kHz)
Signal to Noise Ratio below rated power (20 Hz to 20 kHz)
Total Harmonic Distortion (THD) at rated power, from 20 Hz to 20 kHz
Intermodulation Distortion (IMD) 60 Hz and 7 kHz at 4:1,
from 163 milliwatts to full bandwidth power
Damping Factor: 10 Hz to 400 Hz
Crosstalk (below rated power, 20 Hz to 20 kHz)
Common Mode Rejection (CMR) (20 Hz to 1 kHz)
DC Output Offset (Shorted input)
Input Impedance nominally balanced, nominally unbalanced
Load Impedance (Note: safe with all types of loads)
Stereo
Bridge Mono
Voltage Gain (at maximum level setting, to 1-kHz, 8-ohm rated output)
26 dB setting
1.4V setting
Required AC Mains (configured country-specific)
Power Draw at Idle
Cooling
Dimensions: Width, Height, Depth
Net Weight, Shipping Weight
page 22
CE 1000
560 W
450 W
275 W
1,100 W
900 W
CE 1000
± 0.2 dB
± 15°
> 100 dB
0.5%
< 0.1%
> 400
> 55 dB
> 70 dB
±10 mV
20 k ohms, 10 k ohms
2, 4 and 8 ohms
4 and 8 ohms
26 dB
30.5 dB
50/60 Hz, 100 - 240 VAC
90 watts
Proportional speed fan
EIA Standard 19 in. (48.3 cm) x 5.25 in. (13.34 cm) x 12.25 in. (31.11 cm)
32.6 lb (14.79 kg), 38.6 lb (17.49 kg)
CE Series Power Amplifiers
CE 2000
975 W
660 W
400 W
1,950 W
1,320 W
CE 2000
± 0.2 dB
± 15°
> 100 dB
0.5%
< 0.1%
> 400
> 55 dB
> 70 dB
±10 mV
20 k ohms, 10 k ohms
2, 4 and 8 ohms
4 and 8 ohms
26 dB
32.1 dB
50/60 Hz, 100 - 240 VAC
90 watts
Proportional speed fan
EIA Standard 19 in. (48.3 cm) x 5.25 in. (13.34 cm) x 12.25 in. (31.11 cm)
40.3 lb (18.28 kg), 46.4 lb (20.98 kg)
Operation Manual