Lamp Control - Kenwood FreeTalk UBZ-LH14 Instruction Manual

XILIARY FUNCTIONS
RESET
You may sometimes want to reset all the transceiver
settings fo the factery defaults.
oA
: With the transceiver power OFF,
press and hold the UP and DOWN
_ keys, then press the POWER switch
.* Upon releasing the keys, a beep
sounds and Reset is executed.
LAMP CONTROL
The lamp is used to illuminate the Liquid Crystal Display.
(t turns ON every time you press the UP, DOWN, MODE,
turn the power ON, The lamp will go out after 5 seconds.
+ If you press any key or switch while the lamp is ON, the
larnp timer wil restart the 5 second countdown.
« The lamp stays ON while holding down the UP or DOWN
key to continuously change channels or CTCSS numbers.
ALAR! <}