Panasonic KX-F1050 Operating Instructions Manual page 57

Recording image is faint.
A blank sheet is ejected after the
received documents are printed
out.
• The sender transmitted a faint document. Request them to transmit a
clearer copy of the document.
• The thermal head is dirty. Clean it (p. 64).
oThe receiving reduction rate is not programmed correctly. Program
the proper reduction rate (p. 42).
Operation in EXT. TAM mode
I cannot receive documents
automatically.
I cannot receive voice messages.
I cannot retrieve voice messages
on the answering machine from a
remote location.
The greeting message on your
answering machine is interrupted
and the caller cannot leave a
voice message.
I pressed the remote access code
to access the answering machine
remotely, but the line was
disconnected.
• Your greeting message is too long. Shorten it (up to 10 seconds).
• There are too many rings on the answering machine. Set the number
of rings to less than 3.
• The silent detection feature is deactivated. Activate this feature (p.
48).
• Check that the answering machine is turned on and connected to the
facsimile unit properly (p. 46).
=Set the number of rings on the answering machine to less than 3.
,The remote access code on your answering machine is the same as
the remote fax activation code or the junk mail prohibitor ID on the
facsimile unit. Set a different number for each code/ID.
,Your remote TAM activation code is not programmed correctly.
Program the same code as on the answering machine (p. 47).
• The silent pause in the greeting message is too long. Shorten it to
less than 4 seconds.
=The code may include "#" which is used for certain features offered
by telephone companies. Change the code on the answering machine
so that it does not include "#". Then program the same code into the
facsimile unit (p. 47).
Copying
Dirty patterns or black lines
appear on the copied documents.
The copied image is distorted.
The document is not copied
properly.
A paper jam occurs during
copying.
•The glass or rollers are dirty. Clean them (p. 64).
=The thermal head is dirty. Clean it (p. 64).
• The film is not inserted correctly. Insert it correctly (p. 65).
•The film is not inserted correctly. Insert it correctly (p. 65).
57