Table of Contents
Advertisement
MEMORY DIALING
•
Press MEM/PRG again to exit
memory dial mode and leave the
number on the display.
•
Press PHONE . The number on
the display will be dialed after a 2
second pause.
•
Note that if digits were on the
display prior to entering memory
dial mode, the contents of the
speed dial memory will be
appended to those digits. For
example, if 1503 was on the
display and the contents of the
memory location is 5551212, then
the display would show the
following upon exiting memory dial
mode:
Changing Stored Numbers
To change or replace a stored number
simply enter the new number on the
display and store it in the memory
location you wish to change.
Deleting Stored Numbers
•
Press MEM/PRG . The display will
c h a n g e t o " S P E E D D I A L
LOCATION_ _".
•
Enter memory location number
(00..20).
•
Press CLR/DEL key. The display
will change to "LOCATION XX
DELETED".
AM 1930
•
Press OFF to exit.
NOTE:
Stored numbers are retained in memory
even if the base loses its power or the
handset battery is removed.
Storing Special Codes
To insert a pause in a phone number,
press HOLD/PAUSE at the appropriate
point when entering the number.
This inserts a 2 second pause.
A " P " appears in the display to show
the pause. For longer pauses, press
HOLD/PAUSE two or more times. Each
press makes the pause 2 seconds longer
and is treated as a stored digit.
If your phone is connected to a PBX,
you can store the PBX access number
and a pause before the phone number.
For example, to store 9-PAUSE-555-
1234 in memory location 08, do the
following:
1. Press
2. Press HOLD/PAUSE
3. Enter 5551234
4. Press and hold MEM/PRG
5. Enter 08
31
31
9
9/5/99, 12:14 AM
Advertisement
Table of Contents
