Firmware Update - Polar Electro Mars 2415 Instruction For Users

The data is saved on the USB flash drive in a file called DATALOG.csv.
The DATALOG.csv file can be open with the Polar Charger Analyzer software.
The Polar Charge Analyzer software is included in the USB flash drive supplied with
the charger or can be downloaded from our website www.polar-electronics.com
in download area.
To use the Polar Charge Analyzer software, consult the manual included with the program.
U.L.C. LOG series chargers are equipped with an internal bootloader that allows
to update the installed firmware.
After switching on the charger, the current version of firmware is temporarily displayed
on the screen.
WARNING: After updating the firmware of the charger the current settings
of voltage, current, charge curve and end of charge will be deleted
and restored to factory defaults: that is the maximum voltage and current
available with charging curve WET DEEP and FLOATING).
Per aggiornare il firmware è necessario utilizzare la memoria USB fornita
al caricabatterie, da inserire nell'apposito connettore posto sul pannello frontale
del caricabatterie (vedere pagina 2-3) contenente il file con una nuova versione firmware.
e
With the charger switched off and disconnected from the battery, unscrew the USB
connector cover on the front panel of the charger.
Insert the USB flash drive into the connector.
Switch on the charger.
The screen will display information about
uploading new firmware.
A confirmation message appears when
the upload is completed.
Disconnect the USB flash drive
and screw the connector cover.
After disconnecting the USB flash drive, the charger restarts automatically with the new f
irmware installed.

FIRMWARE UPDATE

Firmware Ver.
Standard :
Battery Charger
U.L.C.
0.11
24.