Operation - Husqvarna PA310 Operator's Manual

6. The chain is correctly tensioned when it
does not sag from the underside of the bar,
but can still be turned easily by hand. Hold
up the bar tip and tighten the bar nuts with
the combination wrench.
7. When fitting a new chain, the chain tension
has to be checked frequently until the
chain is run-in. Check the chain tension
regularly. A correctly tensioned chain
ensures good cutting performance and
long life.
To adjust the harness
Always use the harness when you operate the
product. The harness gives maximum control
during operation of the product. The harness
decreases the risk of tiredness in your arms
and back.
1. Put on the harness.
2. Attach the product to the harness support
hook.
3. Adjust the length of the harness until the
support hook is roughly level with your
right hip.
Introduction
WARNING:
understand the safety chapter
before you use the product.
2106 - 001 - 07.08.2023

Operation

Read and
WARNING:
occurs, let go of the product and
let it fall to the ground.
To fill with oil
1. Push the middle of the oil cap and turn it
counterclockwise to open it.
2. Fill with saw chain oil.
3. Attach the cap again.
4. Turn the oil cap clockwise until it is fully
attached.
5. Push the middle of the cap to close it.
To check before starting
1. Inspect the working area. Remove any
objects that could be thrown out.
2. Check the cutting attachment. Never use
blunt, cracked or damaged equipment
If an emergency
9