Operation - Husqvarna 525DEPS Operator's Manual

To assemble the impact guard
1. Assemble the guard with 3 screws.
2. Tighten the screws to 30 ft/lbs (4 Nm).
3. Tighten the screws again when the product has
been in use for about 20 hours.
To attach the harness support hook
• Attach the harness support hook on the product
with the spacer, the bolt, the nut and the knob.
Introduction
WARNING:
product, you must read and understand
the safety chapter.
To check before starting
1. Inspect the working area. Remove any objects
that could be thrown out.
2. Check the saw chain. Never use blunt, cracked
or damaged equipment.
3. Check that the product is in perfect working
order.
4. Check that all nuts and screws are tight.
5. Make sure the chain is adequately lubricated,
To check the chain lubrication on page
refer to
24 .
6. Check that the saw chain always stops when the
engine is idling.
7. Only use the product for the purpose it was
intended for.
12

Operation

Before you operate the
To adjust the harness
Always use the harness when you operate the
product. The harness gives maximum control during
operation of the product. The harness decreases the
risk of tiredness in your arms and back.
1. Put on the harness.
2. Attach the product to the harness support hook.
3. Adjust the length of the harness until the support
hook is roughly level with your right hip.
8. Make sure the handle and safety features are in
order. Never use a machine that has any parts
missing or has been modified in relation to the
specification.
Fuel
This product has a two-stroke engine.
CAUTION:
result in engine damage. Use a mixture
of gasoline and two-stroke oil.
Premixed fuel
• Use Husqvarna premixed alkylate fuel for best
performance and extension of the engine life.
This fuel contains less harmful chemicals
compared to regular fuel, which decreases
harmful exhaust fumes. The quantity of remains
after combustion is lower with this fuel, which
keeps the components of the engine more clean.
Incorrect type of fuel can
1480 - 007 - 15.02.2021