Husqvarna PA310 Operator's Manual page 10

3. Check that the machine is in perfect
working order.
4. Check that all nuts and screws are tight.
5. Make sure the chain is adequately
lubricated. Refer to
9 . Do a check of the oil level periodically
during operation.
6. Make sure that the cutting attachment
always stops when you release the throttle/
power trigger.
7. Only use the product for the purpose it was
intended for.
8. Make sure the handle and safety features
are in order. Never use a machine that has
any parts missing or has been modified in
relation to the specification.
To use the product
WARNING:
applicable safety regulations for
work in the vicinity of overhead
power lines.
WARNING:
underneath a branch that is being
cut. This could lead to serious or
even fatal personal injury.
WARNING:
electrically insulated. If the product
touches or comes close to high-
voltage power lines it could lead
to death or serious bodily injury.
Electricity can jump from one point
to another by arcing. The higher the
voltage, the greater the distance
electricity can jump. Electricity can
also travel through branches and
other objects, especially if they
are wet. Always keep a distance
of at least 30 ft (10 m) between
the product and high-voltage power
lines and/or any objects that are
touching them. If have to work
within this safe distance you should
always contact the relevant power
company to make sure the power is
switched off before you start work.
WARNING:
a long reach. Make sure that no
10
To fill with oil on page
Observe the
Never stand directly
This product is not
This product has
people or animals come closer than
50 ft (15 m) when the product is
running.
WARNING:
throttle/power trigger without having
the cutting attachment in full view.
• Hold the product as close to your body as
possible to get the best balance.
• Make sure that the tip does not touch the
ground.
• Do not rush the work, but work steadily
until all the branches have been cut back
cleanly.
• Release the throttle/power trigger after
each working operation. Long periods at
full throttle/speed without any load on the
engine/motor can cause serious engine/
motor damage.
• Always work at full throttle/speed.
• Observe great care when working close
to overhead power lines. Falling branches
can result in short-circuiting.
• Whenever possible position yourself so
that you can make the cut at right angles to
the branch.
• Do not work with the shaft held straight
out in front of you (like a fishing rod) as
this increases the apparent weight of the
cutting attachment.
Never activate the
90°
2106 - 001 - 07.08.2023