Tools You Will Need - GE PSA1200 Installation Instructions Manual

Installation Instructions
TOOLS YOU WILL NEED
TE)
| and #2 Phillips screwdriver
Pencil
Tin snips (for cutting
damper, if required} Scissors
(to cut template, if necessary)
Gas
Saw (saber, hole or keyhole}
Gloves
Ruler or tape measure
OF and straight edge
1
————
Stud finder or
Carpenter square
(optional)
Electric drill with %48", "As",
4" and %" drill bits
Filler blocks or scrap
wood pieces, if needed
for top cabinet spacing
{used on recessed bottom
cabinet installations only)
a i
Hammer (optional)
Safety goggles
_————— a |
Level Duct and masking tape
MOUNTING SPACE
13" max.
~—
Bottom edge of
_—— cabinet needs to
be 30" or more
from the cooking
surface
I Ll
——~ Backsplash
66" or more
from the floor
to the top of
the oven
NOTES:
¢ The space between the cabinets must be 30" wide
and free of obstructions.
e If the space between the cabinets is greater than
30", a Filler Panel Kit ray be used to fill in the gap
between the oven and the cabinets. Your Owner's
Manual contains the kit number for your model.
¢ This oven is for installation over ranges up to
36" wide.
¢ If you are going to vent your oven to the outside,
see Hood Exhaust Section for exhaust duct
preparation.
¢ When installing the oven beneath smooth, flat
cabinets, be careful to follow the instructions
on the top cabinet template for power cord
clearance.
¢ Maximum cabinet depth above and beside the unit
is 13".
* For models with top venting holes: Do not allow
cabinetry or other objects to block the airflow of the
vent.
¢ The product should not be installed over any
cooktop or range with a combined BTU greater
than 60000 BTU.